Cleaning And Maintenance - Ferm WSM1008 Traducción Del Manual Original

button (2) pressed and simultaneously press the
The laser is used for projection of the cut on the
wall.
switch (8).
machine is overloaded.
machine is not overloaded. The machine can
be used normally.
machine is overloaded. Apply less pressure on
the machine.
the machine is fully overloaded. The machine
will be switched off.
vacuum device which is approved for stone dust.
The vacuum device must be suitable for the
material to be worked. Use a special vacuum
device when working with toxic materials or
where toxic dust is produced.
use of a household vacuum cleaner can easily
damage both your health and the vacuum
cleaner.
- Always use the dust extraction adapter.
is securely connected to the dust extraction
adapter.
immediately, switch off the machine, remove
the mains plug from the mains, and try to solve
the problem.
turning it clockwise until it locks into place.
dust extraction adapter (25).
Hints for optimum use
guide the cutting discs.
slot depth (recommended). The machine is
placed against the wall and the cutting discs
lower into the wall in order to set the slot depth
more accurately.
- Set the slot depth and lower the machine into
the wall.
drawn lines on the wall.
wall.
machine to come to a complete standstill
before putting the machine down.

CLEANING AND MAINTENANCE

Before cleaning and maintenance,
always switch off the machine and
remove the mains plug from the mains.
remove dust and dirt from the ventilation slots.
inaccuracies during use.
Checking and replacing the carbon brushes
the carbon brushes are worn, the machine will
start to run unevenly.
Only use the correct type of carbon
brushes.