Clatronic MWA 3101 Instrucciones De Servicio página 27

Ocultar thumbs Ver también para MWA 3101:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 14
CAUTION:
Before filling in water!
Insert the drainage hose (7) into the device at the top of
the washing machine in order that water cannot flow out
again immediately.
Always put the washing into the machine first! Otherwise
the maximum water level might be exceeded and the
machine might overflow during the washing process.
There are two methods of filling with water.
1. Bucket/Bowl:
You can fill in the water through the open lid by means of a
bucket.
2. Hose:
Together with the hose the connection (5) serves as a
method of filling. Please use the new hose supplied and
connect one end to the washing machine.
You can connect the other funnel-shaped end of the
hose carefully to a water tap and fill in water in a cont-
rolled manner via the tap.
Under no circumstances should the maximum filling height be
exceeded.
Washing
The machine is only suitable for washing textiles up to the stated
filling quantity.
Empty the pockets of the clothing that is to be washed.
It is best to wash particularly high-quality or sensitive
clothing in a washing bag or white pillow cover.
Laundry that is particularly soiled should be pre-washed
once.
Washing and Washing Powder
Determine the washing temperature in accordance with the
care instructions attached to the garments to be washed.
However, you should not wash anything above 50°C.
NOTE:
Your washing machine does not have its own heating sys-
tem. You should therefore mix the water to the appropriate
temperature beforehand.
Determine the length of washing in accordance with the care
instructions and the degree of soiling.
The following table is intended to help you determine the amount
of washing powder you require.
Washing
Water
Quantity
Quantity
1,2-1,5 kg
approx. 13 l
1,0-1,2 kg
approx. 10 l
Up to 1,0 kg
approx. 7 l
05-MWA 3101.indd 27
Washing
Washing
Powder
Powder
Concentrate
Consump-
Consumption
tion
15 g
20 g
10 g
17 g
5 g
14 g
Operation
Preparation
Insert the drainage hose (7) into the device at the top of the
washing machine.
Place the washing in the machine.
Fill in the water and the washing powder. See also the
section on „Washing and Washing Powder".
Close the lid.
Electrical Connection
Please ensure that the timer is turned to „0"(off).
Connect the mains lead to a properly installed 230 V, 50 Hz
socket.
Washing
Set the desired washing time by means of the timer.
Stopping Operation
Wait until the clock automatically stops the washing process
or turn the timer back to the „0" position.
Remove the plug from the socket.
Take an appropriate vessel of an adequate size in order to
drain off the dirty washing water via the drainage hose. To
this purpose you should remove the drainage hose from the
device and place it in the selected vessel.
You can now remove the washing or rinse it again if neces-
sary.
Close the lid and insert the drainage hose.
Cleaning
Remove the mains plug from the socket.
In order not to damage the surfaces you should not use any
abrasive detergents or cleaning equipment that will scratch.
Washing Drum
Clean the lint screen.
We recommend cleaning the washing drum with clear water
after washing is finished.
It is extremely advisable to do this after you have been was-
hing with starch or bleach in order that the following washing
is not affected by this.
Any soiling of the washing drum can be removed with a
sponge or nylon brush.
Housing
The housing can be wiped off with a slightly damp cloth. Do
not immerse the motor device into water!
Dry all parts after cleaning with a dry cloth.
Storage
Empty the washing drum completely.
Close the lid.
27
05.11.2009 13:59:35 Uhr

Publicidad

Tabla de contenido
loading

Tabla de contenido