Advanced Settings - switel DC2000 Manual De Instrucciones

Display language (PERSONAL SET -> LANGUAGE)
Select the language for the display.
Room monitor (PERSONAL SET -> ROOM MONITOR)
(only with several suitable handsets at the same base)
If set to on, this handset can be brought into the room you want to monitor.
Only the microphone is switched on. Nobody in this room can hear you.
Press INT on a second handset and enter the number of the handset you
are using for room surveillance. You can now hear sounds from the room.
Note: To stop the room monitoring at any time, press the hang up key.
IMPORTANT: This feature is not intended for use as a baby monitor and
does not replace adult supervision.
Backlight (PERSONAL SET -> BACKLIGHT)
You can turn the display backlight on or off.

Advanced settings

Advanced settings are described below. You can access the corresponding
function via the menu (see menu structure).
Recall time (ADVANCED SET -> RECALL TIME)
Select the length of the flash signal to use network features or to operate
on a PBX. If necessary, contact your network operator for information.
Dialling mode (ADVANCED SET -> DIAL MODE)
Choose between tone dialing and pulse dialing. If necessary, contact your
network operator for information.
Call barring (ADVANCED SET -> CALL BARRING)
Switch the function on and enter up to four 4-digit numbers that are to be
blocked (eg international code or national prefixes, etc.). The required PIN
is "0000" in the delivery state.
Easy Call (ADVANCED SET -> EASY CALL)
When this feature is enabled, only a specific stored number can be dialed
by pressing any key on the handset (except the end call key).
The required PIN is "0000" in the delivery state.
Easy Call can only be switched on if a phone number has been
programmed. To switch off the Easy Call, press the end call key and switch
off the function.
26