Mounting The Cable Strain Relief - Miele professional XCI-Box-LG Instrucciones De Manejo

Mounting the cable strain relief

The connection cables of external hard-
ware must be fastened to the XCI box
using cable glands and cable strain re-
lief fixtures. See figure in section "" at
the end of these operating instructions.
 Remove the lid from the XCI box (re-
move the 2 screws).
 Remove one or more of the cable
strain relief fixtures a.
 Stand the XCI box on its narrow end
so that the sealed connection holes
are at the top.
 Using a screwdriver, press out the
round indentation in the connection
hole b.
Tip: Pierce through the groove round
the edge at several places using a
screwdriver.
 Insert the counter nut c.
 Screw on the threaded fitting d.
Tip: Slide the screw cap e over the
end of the connection cable for the ex-
ternal hardware.
 Guide the connection cable through
the threaded fitting and into the XCI
box.
 Tighten the screw cap.
The screw cap provides protection
against moisture and dust.
 Secure the connection cable with the
strain relief f.
 Make the required connections for
the external hardware in the XCI box.
 Close the lid on the XCI box (screw in
the 2 screws).
Legend for cable strain relief in section
""
a Cable strain relief fixtures
b Connection hole
c Counter nut
d Threaded fitting
e Screw cap
f Cable strain relief with screws
Configuration
Once the XCI box has been installed,
the settings for the external functions
have to be made on the corresponding
Miele Professional machine.
Follow the instructions provided in the
operating and installation instructions
for the Miele Professional machine.
To enable communication with external
hardware (payment system, dispensing
unit, etc.), settings/configurations need
to be made on the Miele Professional
machine.
en - English
35