Assembly And Adjustment - BTI RS 1050 E Instrucciones De Manejo

E N G L I S H
Mains plug replacement
(U.K. & Ireland only)
• Should your mains plug need replacing and you are
competent to do this, proceed as instructed below.
If you are in doubt, contact an authorized BTI repair
agent or a qualifi ed electrician.
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely; a plug with
bared copper conductors is dangerous if engaged
in a live socket outlet.
• Only fi t 13 Amperes BS1363A approved plugs fi tted
with the correctly rated fuse (1).
• The cable wire colours, or a letter, will be marked
at the connection points of most good quality plugs.
Attach the wires to their respective points in the plug
(see below). Brown is for Live (L) (2) and Blue is for
Neutral (N) (4).
• Before replacing the top cover of the mains plug
ensure that the cable restraint (3) is holding the outer
sheath of the cable fi rmly and that the two leads are
correctly fi xed at the terminal screws.
Never use a light socket.
Never connect the live (L) or neutral (N) wires
to the earth pin marked E or
For 115 V units with a power rating exceeding 1500 W, we
recommend to fi t a plug to BS4343 standard.
Using an extension cable
If an extension cable is required, use an approved
extension cable suitable for the power input of this
machine (see technical data). The minimum conductor
size is 1.5 mm². The cable has to have a rubber jacket
and a grounding conductor. When using a cable reel,
always unwind the cable completely.
Also refer to the table below.
Conductor size (mm²) Cable rating (Amperes)
0.75
1.00
1.50
2.50
4.00
Voltage Amperes
230

Assembly and adjustment

Mounting the saw blade (fi g. B)
• Move the blade clamp lever (2) up to release the
blade clamping mechanism.
• Insert the saw blade into the holder (4) until it
engages. The blade can be installed with the teeth
pointing down or up, or left or right.
• Move the blade clamp lever (2) down to lock the
blade clamping mechanism.
• To remove the saw blade, proceed in reverse order.
Saw blades
.
material
ferrous metal
non ferrous metal
wood
plastic
masonry
A wide variety of dedicated saw blades is available as
an option.
Instructions for use
14
6
10
15
20
25
7.5 15 25 30 45 60
Cable rating (Amperes)
0 - 2.0 6 6
2.1 - 3.4 6 6
3.5 - 5.0 6 6
5.1 - 7.0 10 10 10 10 15 15
7.1 - 12.0 15 15 15 15 20 20
12.1 - 20.0 20 20 20 20 25 -
Prior to assembly and adjustment always
unplug the tool.
recommended saw blade
Always select your saw blade with great care.
• Always observe the safety instructions
and applicable regulations.
• Ensure the material to be sawn is secured
in place.
Cable length (m)
6 6 6 6
6 6 6 6
6 6 10 15
fi ne-toothed
coarse-toothed
coarse-toothed
fi ne-toothed
carbide-tipped