Panasonic AG-MBX10G Instrucciones De Funcionamiento página 14

 Checking Bus Power Operation
Check the following before performing any copy operations with the unit when using bus power.
Note that the result of this check may not fully guarantee bus power operation on your PC.
Install the AG-MBX10G
interface box in the AG-MSU10,
check that no important data
remains and format the SSD
using the FAT format.
Connect the supplied USB cables
from the USB connectors on the
PC to the USB 2.0 connectors
(SIGNAL, POWER) on the unit.
To use an eSATA connection,
also connect the eSATA cable.
Did the drive appear
on the PC?
No
C
E-
In Explorer (Windows) or the
Finder (Macintosh), select the
drive and load the files (copy or
create anew).
(Copy about 100 MB worth of
files to the SSD.)
What was the result of
loading the files?
Yes
The operation
ended normally
Did the WARNING
lamp of the AG-MBX10G interface
box light once or more
during operation?
No
A
A
USB bus power can
be used to power the
system.
B
The operation
There may not be enough
ended in an error
power to run the system.
C
Use it installed in the
AG-MSU10.
C
USB bus power cannot
provide sufficient power.
Use it installed in the
Yes
B
AG-MSU10.