Ibiza Light DJLIGHT65 Manual De Instrucciones página 4

COL COLO
↔
DMX D001/d512
↔
SLA SLAN
↔
SYS ASEN
↔
Operation
DMX address code setting: Press "MENU" button. When the digital LED displays d001-d512, press "UP" or
"Down" to set the address code. The code ranges from 001-512.
When controlling the unit(s) with a DMX controller, each unit must be set to a specific DMX address. You can set
either all units to the same DMX address or you can set every unit to a different DMX address. If all units are set
to the same DMX address, they are all synchronized and operate the same way.
If every unit has its own DMX address, they will receive the DMX signal that is specific to their address and you
can control every unit separately. The DMX address is determined by the number of channels. The units can
work either in 3-channel, 7-channel or 11-channel mode. If you set the starting address to 1, the second unit
must be set either to 4 (1+3 in 3-CH mode) or to 8 (1-7 in 7-CH mode) or to 12 (1+11 in 11-CH mode), etc.
Connection of Signal Cable
You can use the 3-pin XLR cable to connect the OUT socket of the first light and the IN socket of the following
light. Connect all the lights as below:
A DMX signal terminator is recommended on the last unit of the chain. DMX terminator is a XLR connector with
a 120Ω resistor between the pin 2 and pin 3 of the XLR connector
©Copyright LOTRONIC 2016
R 0-255
G 0-255
B 0-255
W 0-255
↔
S00-32
N01-32
3CH
7CH
↔
11CH
SN01-SN04
↔
4
Red
Green
Blue
White
Strobe
Motor
speed
Channels
Channels
Channels
Sound-activated sensitivity
DJLIGHT65