ENGLISH
Getting Started
Accessories
Check that the following parts are attached in addition to the main
unit:
q
Operating instructions .............................................................1
w
Service station list....................................................................1
e
Remote control unit (RC-1032) ................................................1
r
R03/AAA batteries ...................................................................2
t
Pin-plug cable (Cable length: Approx. 1.0 m)...........................1
e
r
Before using
• Handle the power supply cord carefully.
Do not damage or deform the power supply cord. If it is damaged or
deformed, it may cause electric shock or malfunction when used.
When disconnecting the power supply cord from the wall outlet,
hold the plug and do not pull on the cable.
• Do not open the top cover.
In order to prevent electric shock, do not open the top cover.
If problems occur, contact your DENON dealer.
• Do not place anything inside.
Prevent metal objects from entering the CD player and avoid spilling
liquids on it.
Electric shock or malfunction may result.
• Cautions on moving.
First, if a disc is loaded, eject it, then turn off the power, unplug the
power supply cord from the power outlet and disconnect the
connection cables with other devices.
• Cautions on using mobile phones.
Using a mobile phone near this unit may result in noise. If so, move
the mobile phone away from this unit when it is in use.
• Store these instructions in a safe place.
After reading, store this instructions along with the warranty card in
a safe place.
• Note that the illustrations in these instructions may differ from
the actual unit for explanation purposes.
NOTE:
• This CD player uses a semiconductor laser. To ensure stable
operation, it is recommended to use the set indoors at a
temperature of 5°C (41°F) ~ 35°C (95°F).
About discs
Discs usable on this set
q
Music CDs
Discs with the mark at the right can be used on
this set.
Note however that discs with special shapes
(heart-shaped discs, octagonal discs, etc.) cannot
be played. Do not attempt to play them, as doing
t
so could damage the set.
w
CD-R/CD-RW
• Some discs and some recording formats may not be playable.
• Non-finalized discs cannot be played.
Finalization:
Finalization is the process that makes recorded CD-R/CD-RW discs
playable on compatible players.
Holding discs
Loading discs
• Set the disc with the labeled side facing up.
• Make sure the disc tray is fully open when inserting the disc.
• Place the discs flatly, 12 cm discs in the outer tray guide (Figure 1),
8 cm discs in the inner tray guide (Figure 2).
• Place 8 cm discs in the inner tray guide without using an adapter.
• "00 Tr 00 : 00" is displayed if a disc that cannot be played is
inserted.
• "NO DISC" is displayed if a disc is loaded upside down or if no disc
is loaded.
Do not touch the signal surface.
2
ENGLISH
Figure 1
Figure 2
Outer tray guide
Inner tray guide
12 cm discs
Getting Started
8 cm discs