Technical Data; Before Starting The Equipment - EINHELL RT-CS 190/1 Manual De Instrucciones

Anleitung_RT_CS_190_L_SPK7:_

4. Technical data

Mains voltage:
Power input:
Idling speed:
Cutting depth at 90°:
Cutting depth at 45°:
Saw blade:
Blade holder:
Blade thickness:
Protection class:
Weight:
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Handle
Vibration emission value a ≤ 2.5 m/s
h
2
K uncertainty = 1.5 m/s
Additional handle
Vibration emission value a = 2.664 m/s
h
2
K uncertainty = 1.5 m/s
Additional information for electric power tools
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
28.02.2011 13:51 Uhr
The specified vibration value can be used for initial
assessment of a harmful effect.
230 V ~ 50 Hz
Keep the noise emissions and vibrations to a
1500 W
minimum.
Only use appliances which are in perfect working
-1
5,500 min
order.
66 mm
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
48 mm
Do not overload the appliance.
Ø 190 mm
Have the appliance serviced whenever
Ø 30 mm
necessary.
Switch the appliance off when it is not in use.
2.8 mm
Wear protective gloves.
II / ®
5.2 kg
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain residual
risks cannot be rules out. The following hazards
may arise in connection with the equipment's
construction and layout:
1. Lung damage if no suitable protective dust mask
is used.
2. Damage to hearing if no suitable ear protection is
90,2 dB(A)
used.
3 dB
3. Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or
101,2 dB(A)
is not properly guided and maintained.
3 dB

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate are
identical to the mains data.
Always pull the power plug before making
2
adjustments to the equipment.
5.1 Setting the cutting depth (Figure 2/3)
Release the handle on the rear of the guard hood
for adjusting the cutting depth (4).
2
Place the soleplate (6) flat on the surface of the
workpiece you wish to saw. Raise the saw until
the saw blade (12) is at the required cutting depth
(a).
Refasten the handle for adjusting the cutting
depth (4). Check the handle is securely fastened.
5.2 Miter stop (Figure 4/5)
The preset standard angle between the saw foot
(6) and saw blade (12) is 90°. You can adjust this
angle to carry out angled cuts.
Release the locking lever for miter setting (7) on
the front of the saw foot.
You can now adjust the cutting angle to around
Seite 17
GB
17