Dometic VT 50 WiF Instrucciones De Montaje página 13

VT50WiFi
Mounting the camera under the number plate (fig. 4, page 5)
➤ Unscrew the camera (1) from the assembly plate (2).
➤ Turn the camera by 180°.
➤ Reattach the camera to the assembly plate.
Adjusting the installation position on the rear of the vehicle (fig. 5, page 5)
The camera is attached to the upper part of the assembly plate. The upper part of the assembly
plate is bent at an angle of approximately 5°. You can fit the camera to the rear of the assembly
plate to adjust the assembly position to the shape of the vehicle rear.
➤ Unscrew the camera (1) from the assembly plate (2).
➤ Turn the assembly plate by 180°.
➤ Reattach the camera to the assembly plate.
6.3 Fastening the camera
➤ Remove the rear number plate holder from the vehicle.
➤ Attach the camera assembly plate to the rear of the number plate holder with double-sided
tape.
➤ Reattach the number plate holder to the vehicle. In doing so, press the double-sided tape onto
the bodywork.
✓ The camera is now attached to the vehicle.
6.4 Preparing the transmitter for installation
!
CAUTION!
Select the location of the transmitter so that it cannot injure the passengers in the
vehicle under any circumstances (e.g. sudden braking, road traffic accidents).
Observe the following mounting instructions:
•
Install the transmitter so that as few objects as possible are situated between the transmitter and
receiving device. Moving the transmitter can help if there is a poor connection.
•
The installation location should be flat.
•
Before drilling each hole, ensure there is sufficient space on the other side for the drill head to
emerge (fig. 6, page 6).
•
Make sure you can lay the connection cable from the transmitter to the camera.
I
NOTE
The image is sent from the transmitter to the receiving device. To ensure flawless
functioning, you need to check whether the wireless transmission is stable before final
installation.
EN
Mounting the camera and transmitter
13