Overview Of The Components; Intended Use - AEG SR 4351 CD Instrucciones De Servicio

Overview of the Components

1 Telescopic antenna
2 Handle
3 CD compartment
4 Radio scale
5 TUNING control
6 Tab for opening the CD compartment (LIFT TO OPEN)
7 / button (Play/Pause)
8 LED-display
9 FM ST. control lamp
10 Indicator lamp PLAY/PAUSE (Play/Pause)
11 NEXT button (forward search)
12 RANDOM button (random playback)
13 PROGRAM button (memory)
14 REPEAT button
15 BACK button (reverse search)
16 Indicator lamp PROG. (memory)
17 Indicator lamp REPEAT (repeat)
18 POWER control lamp
19 STOP button
20 VOLUME (volume control)
21 FUNCTION Function selector switch (OFF / CD/AUX /
RADIO)
Back (not shown)
AUX IN connection
AC Mains connection
Bottom side (not shown)
Battery compartment

Intended Use

This device is used for
• The reception of radio programmes
• Playing back audio CDs
• Sound playback from external audio sources.
It is intended exclusively for this purpose and may only be
used as such. It may only be used in the manner described
in these instructions for use. The device must not be used for
commercial purposes.
Any other use of this device is considered to be contrary to
the intended use and may result in damage to materials or
even personal injury.
The firm ETV – Elektro-Technische Vertriebsgesellschaft mbH
does not accept any liability for damage caused as a result of
the use of this device contrary to its intended use.
Start-up of the device/introduction
• Please read the operating instructions carefully before
using the device for the first time!
• Select a suitable location for the device, such as a dry,
flat, non-slip surface on which it is easy to operate the
machine.
• Ensure that the device is sufficiently ventilated!
• Remove the protective film from the display if it is still
present.
Power Supply
• Connect the power cable supplied (see battery compart-
ment if necessary) to a properly installed 230 V / 50 Hz
safety power socket and the mains connector AC ~ on
the back of the machine.
• Ensure that the voltage is the same as that indicated on
the model identification plate.
Inserting the Batteries (not supplied)
• Open the lid of the battery compartment on the bottom.
• Insert 6 batteries of type UM2/R14 1.5 V. Please ensure
that the polarity is correct (see the floor of the battery
compartment)!
• If the device is not used for a long period of time, remove
the batteries to avoid the spilling of battery acid.
• Then close the battery lid.
NOTE:
When a mains cable is connected the batteries are auto-
matically switched off.
CAUTION:
• Different battery types or new and used batteries must
not be used together.
• Batteries are not to be disposed of together with
domestic wastes. Dispose of the used batteries at the
relevant collection bin or at your dealer' s .
WARNING:
The batteries shall not be exposed to excessive heat such
as sunshine, fire or the like. Danger of explosion!
Transport Safety Device, CD Compartment
• Open the CD compartment (3) by pulling the lid up-
wards by the tab (6).
• Before operating the machine for the first time, remove
the transport safety device from the CD player if it is still
in place.
Volume
The desired volume can be sent using the VOLUME regula-
tor (20).
Switch on
After you have set up the power supply, set the function se-
lector (21) to the desired operating mode. Depending on the
previous off-state you need to now keep the
(7) pressed down for approx. 3 seconds to turn on the device.
The indicator lamp POWER (18) lights up.
English
31
/ button