During Use - Brandt BPI 6420 X Manual De Instrucciones

5
For light dirt, use a disinfectant sponge.
Thoroughly moisten the zone to be cleaned with
hot water, then wipe off (5).
For a build-up of baked-on dirt or sweet
overflows, use a disinfectant sponge and/or a
special glass scraper. Thoroughly moisten the
zone to be cleaned with hot water. Use a scraper
for glass to remove the large bits, finish off with
a disinfectant sponge, and then wipe off.
For rings and hard water residue, apply warm
white vinegar to the stain, leave on, then wipe
with a soft cloth.
For shiny metal streaks or weekly maintenance,
use a special vitroceramic glass product.
Important note: do not use any powders or
abrasive sponges. Use creams and special
delicate glassware sponges.
6
6.1
DURING INITIAL USE:
- An indicator light appears. This is normal. It
will go away after 30 seconds.
- Your installation blows a fuse or one side
only of the hob works. The electrical
connection of your hob is incorrect. Check its
compliance (see connection chapter 1.3).
- The hob smells the first few times it is used
for cooking. The appliance is new. Heat up each
ring for half an hour with a saucepan full of water.
6.2
WHEN POWERING ON:
The hob does not work and the indicator
lights on the control panel are not on.
The appliance is not receiving electricity. The
electrical supply is defective or the connection is
incorrect. Inspect the electrical circuit breaker
and fuses.
- The hob does not work and another
message is displayed. The electronic board is
functioning poorly. Call the After-Sales Service
Department.
- The hob does not work, the symbol
is displayed. Unlock the child safety device (see
connection chapter 4.4).
- Error code F9: voltage less than 170 V
- Error code F0: voltage less than 5°C
6.3

DURING USE:

- The hob has stopped working. The symbol
is displayed and there is a sound
signal.
There was an overflow or an object is in
contact with the control panel. Clean or
remove the object, then begin cooking again.
- Code F7 is displayed.
The electronic circuits have overheated. Check
the hob's ventilation (see chapter on fitting
1.2).
- During operation of a heating zone, the
keypad display continues to flash.
The cookware used is not compatible with
induction or its size is not suitable for the
burner (see chapter 3).
- The cookware makes noise and your hob
clicks during cooking (see chapter on Safety
precautions and recommendations 4.5).
This is normal with some types of cookware. This
is caused by the transfer of energy from the hob
to the cookware.
- The fan continues to function after your hob
is turned off.
This is normal. It cools the electronic parts.
- In the event of persistent malfunction.
Switch off your hob for 1 minute. If the problem
persists, contact the after-sales service.
7
Protecting the environment
This symbol indicates that this product
should not be treated as household
waste.
Your appliance also contains a great
amount of recyclable material. It is marked with
this symbol to indicate that used appliances must
be disposed of in certified collection points.
Contact your town hall or your retailer for the
used appliance collection points closest to your
home. This way, the appliance recycling
organised by your manufacturer will be done
under the best possible conditions, in compliance
with European Directive on Waste Electrical and
Electronic Equipment.
This appliance's packing materials are also
recyclable. Help recycle it and protect the
environment by dropping it off in the municipal
receptacles provided for this purpose.
We thank you for your help in protecting the
environment.