Brother KIT CW Guia De Instalacion página 21

c
Install the cutwork needle in the cutwork
needle-changing tool.
Hold the cutwork needle-changing tool with the notch
upward. With the needle point down, insert the
cutwork needle into the mounting hole.
Insert the needle so that the shape of the needle base
aligns with the shape of the mounting head in the tool.
a Mounting hole
b Notch
c Needle base
d Mounting head
Note
• When inserting the cutwork needle in the
cutwork needle-changing tool, the needle
should naturally hold in place when it is
released, without unnecessary force
applied.
INSTALLING THE CUTWORK NEEDLES
d
With the flat side of the needle toward the
back of the machine, insert the needle into
the needle chamber, pushing the needle
upwards until it touches the needle bar
stopper.
Hint: Pass the needle through the hole in the presser
foot first, and then use the cutwork needle-changing
tool to lift up the needle.
a Needle bar stopper
b Needle
c Flat side of needle
d Cutwork needle-changing tool
Note
• Install the cutwork needle with the color and
number corresponding to the needle bar on
the machine, referring to "About the
Cutwork Needles" on page 15.
e
While holding the needle in place with your
left hand, tighten the needle set screw.
Use the Allen screw driver to turn the needle set screw
clockwise.
CAUTION
• Cutwork needles are shorter than traditional
embroidery needles, be sure to insert the needle in
the needle bar chamber until it reaches the needle
bar stopper and securely tighten the needle set
screw with the Allen screw driver, otherwise the
needle may break or the machine may be damaged.
■ Recommended time for replacement
The cutwork needles must be replaced if any of
the following occur.
A loud noise is produced when it pierces the fabric.
As compared to immediately after the needle has
been replaced, there are prominent uncut areas (the
cut edges are rough, etc.).
Nicks can be seen in the blade.
Note
• When replacing the needles, be sure to use
cutwork needles specifically for embroidery
machines. To purchase the cutwork needle
set, contact your nearest authorized dealer.
17