Beninca SIMPLE-RI Manual De Instrucciones página 7

The transmitter storing procedure is as follows:
1 Press and release button P on the receiver.
2 The Red LED will illuminate for 3 seconds, go off for 3 seconds, and then illuminate again for 5
seconds.
3 While the Red LED is on, press the button on the transmitter that you want to store with
automatic function.
4 More transmitters can be added later by pressing a button during the 5 seconds following the
previous transmitter addition.
5 At the end of the procedure, wait for 5 seconds until the receiver exits the programming
mode.
To reset the receiver:
Cut off power supply, press push button P and, keeping it pressed, power the unit again. The LED
switches on with fixed red light, and after about 5 seconds, the LED starts flashing with alternate
colours. Release the push button and the receiver will be reset and all transmitter codes erased.
NOTE:
Both radio channels are used by the control module. The second channel is therefore unavailable
for other uses.
The RR.2WIV-SIMPLE receiver can only be used with SIMPLE/SIMPLE-RI control modules. It
is not permitted to use the receiver with other control modules as this can lead to malfunctions.
The maximum duration of the opening/closing movements commanded via the transmitter
is factory set to 60 seconds. After this interval has elapsed, the control module will return
automatically to its STOP condition.
If you wish to activate the MANNED MODE operation, remove the receiver from the slip-on
connector and set both dip-switches to OFF.
This mode requires that the OPEN/CLOSE buttons be pressed and held for the whole duration of
the opening/closing movement.
MANNED mode operation
7