Guided Tour - St5 - Samson Stage 55 Manual De Instrucciones

Guided Tour - ST5

1 2 3
LOW MID HIGH
B AT T E RY L E V E L
AUDIO ON
1: Input connector - The input device is connected here. The ST5 is supplied with either a lava-
liere, headset microphone or heavy-duty instrument cable terminating with a 1/4" plug, which
are all connected to the transmitter via a locking 3.5mm mini-phone jack.
2: Battery level meter - This set of three multicolor LEDs indicates relative battery power, indi-
cating whether the installed battery is at low (red), mid (yellow) or high (green) strength. One or
more of these will light whenever the SR5 or ST5 is powered on (see #5 on the next page). When
all three are lit, the battery is at maximum strength. When only the red "low" indicator lights, RF
performance is degraded and the battery needs to be replaced.
3: Audio on-off switch - When set to the "on" position, audio signal is transmitted. When set
to the "off" position, the audio signal is muted. Because the carrier signal remains during mut-
ing, no "pop" or "thud" will be heard. Note that turning this off does not turn off the transmitter
power—it is simply a way to temporarily mute the transmission of audio signal. If you don't
plan on using the transmitter for extended periods, turn off the transmitter power by using the
power on-off switch (see #5 on the next page).
4: Battery door release - Press gently inward on these two indents in order to open the battery
door of the ST5L or ST5 and access the Power on-off switch (see #5 on the next page) and Gain
control (see #6 on the next page).
5: Power on-off switch* - Use this to turn the ST5 on or off (to conserve battery power, be sure
to leave it off when not in use).
4
4
7