Cleaning And Maintenance - Bimar DA19 Manual De Instrucciones

6. Press the "cromia" button to activate the coloured light effect. The lights change hue and
alternate slowly. It is possible to have the fixed light in one of 15 available shades: by
pressing the button, the lights change hue or intensity. When holding down the button for a
few seconds, the lights go out and the unit is in standby mode.
7. The vapour stops when the water runs out, the lights turn off, and you will hear a "beep":
the appliance goes into "stand-by" mode.
8. To fill the tray once again, repeat the steps described in 1, 2, 3 and 4.
9. To turn the appliance off, remove the adaptor from the plug point.
10. After each use the water tray should be emptied and the tray, the lid and the diffuser rinsed.
Dry them with a clean cloth; even when using a different type of essential oil.
For long periods of inactivity, remove the plug from the plug point, make sure the water
tray and the inside of the base are perfectly dry.

CLEANING AND MAINTENANCE

Warning: turn the appliance off and unplug it before cleaning.
Descaling
If the appliance is used frequently and if the water is very hard, it is recommended to remove
the limestone from the appliance in order to extend the lifespan of the appliance and its
accessories.
Water tray and disc made of cermamic:
d) Add 10/15 drops of white vinegar (8%) or a descaling substance to the water tray for 5
minutes.
e) Making sure that water does not enter through the hole in the side of the tray (the air
outlet), rinse thoroughly by adding water inside and then make sure it is completely dry.
f) Avoid the use of abrasive products, solvents, acids that damage the surface finish; Do not
use steel wool or abrasive products. Do not wash it under running water, do not immerse it
in water, do not wash it in the dishwasher. Before use, ensure it is perfectly dry.
Diffuser and cover
Clean them with a soft cloth slightly dampened with water and vinegar, then rinse with a soft
cloth dampened with water only. Avoid the use of abrasive products, solvents, acids that
damage the surface finish; Do not use steel wool or abrasive products. Do not wash in the
dishwasher. Before use, ensure they are perfectly dry.
Cleaning
• The water tray and the lid must be cleaned periodically: the water must be emptied after
each use, wash with soapy water and rinse them with care to avoid the formation of dirt and
limescale. Do not wash it under running water, do not immerse it in water, do not wash it in
the dishwasher. Avoid the use of abrasive products that can damage the filter and the
surface finish; do not use steel wool or abrasive products. Before use, ensure they are
perfectly dry.
• Failure to maintain and clean the appliance could lead to the formation of micro-organisms
in the water. The following cleaning operations, therefore, must be performed regularly in
order to ensure correct and efficient operation of your humidifier, We cannot emphasise
enough the importance of correct and constant cleaning of the unit in order to prevent the
formation of bacteria and algae inside the unit.
• Periodically check that the vapour outlet is not blocked.
14