Caution : Set the FUNCTION select switch to "off" position before connection .
Connect to other MP3 player to provide sound output from this system.
Preparation
1. Use the unit's "LINE IN" cable to connect other MP3 player's audio "LINE OUTPUT" or
"Earphone Output".
2. Set the Function Switch to "Line in" position. "Siren Light" will flash three times and
"chirp - chirp - chirp" sound will be heard.
3. Adjust the "MASTER VOLUME" to increase or decrease sound level.
4. To turn the unit off, set the Function Switch to "off" position.
Only use discs bearing the audio compact disc identification logo.
Caring for Discs
• Handle the disc carefully. Hold the disc only by its edges. Never
allow your fingers to come in contact with the shiny, unprinted
side of the disc.
• Do not attach adhesive tape, stickers, etc. to the disc label.
• Clean the disc periodically with a soft, lint-free, dry cloth.
Never use detergents or abrasive cleaners to clean the disc.
If necessary, use a CD cleaning kit.
• If a disc skips or gets stuck on a section of the disc, it is probably
dirty or damaged (scratched).
• When cleaning the disc, wipe in straight lines from the center of the disc to the outer edge
of the disc. Never wipe in circular motions.
• Discs should be stored in their cases after each use to avoid damage.
• Do not expose discs to direct sunlight, high humidity, high temperatures or dust, etc.
Prolonged exposure or extreme temperatures can warp the disc.
• Do not stick or write anything on either side of the disc. Sharp writing instruments, or the
ink, may damage the surface.
Cleaning the Unit
• To prevent fire or shock hazard, disconnect your unit from the AC power source when
cleaning.
• The finish on your unit may be cleaned with a dust cloth and cared for as other furniture.
Use caution when cleaning and wiping the plastic parts.
• Mild soap and a damp cloth may be used on the front panel.
LINE IN OPERATION
CARE AND MAINTENANCE
GB - 6