unit diagram - FRONT PANEL
These features are the same across all TerraNova amplifier and combos.
1.
Active Input: Plug your active or high output bass in here.
2.
Passive Input: Plug your passive or low output bass here.
3.
Mute LED: When the amplifier is muted this light will illuminate.
4.
Mute Switch: Press this switch to mute and unmute the amplifier.
5.
Compressor Light: This LED will illuminate when the compressor
feature is switched on.
6.
Compressor Switch: Use this switch to turn the built in compressor
circuit off and on.
7.
Input Gain: Use this control to adjust the amount of signal sent into
the preamp stage. Use in conjunction with the Input Gain clip light
to avoid clipping the input stage of the amplifier.
8.
Input Gain Clip Light: When illuminated this LED shows clipping
is occurring in the preamp. To prevent this either turn down the
output of your instrument, or dial the Input Gain to a lower setting.
9.
Enhance: Use this control to adjust the amount of Enhance added
to your EQ setting. This EQ sweep allows quick and effective
8
Quick Start Guide | Terra Nova Amplifiers & Combos
adjustment of your EQ with a single dial. For best results use the
Enhance control with all other EQ settings at 12 O'clock before
detailing your tone.
10. Enhance Light: When illuminated this LED indicates the
Enhance feature in the amplifier is turned on.
11. Bass: Adjust the low frequencies of the amplifier using this
control.
12. Bass Boost Switch: Use this switch to turn on the Bass boost
feature on the amplifier. When engaged the Bass control will
provide more pronounced Bass adjustment.
13. Bass Boost Light: when illuminated this LED indicated the Bass
boost feature is turned on.
14. Low Mid Freq Sweep: Adjust the frequency affected by the Low
Mid control from 30 Hz up to 300 Hz using this control.
15. Low Mid Control: Change the amount of frequency adjustment
by the low mid freq sweep using this dial.
16. Hi Mid Level Control: Adjust the frequency affected by the
upper mid freq sweep using this control.