HOW TO USE
Before using your chocolate fountain please check the 3 plastic spacers of the auger, located on the
plastic base inside the stainless bowl. Make sure the auger column is firmly locked in position.
1. Place your chocolate fountain on a flat and stable surface.
2. Choose the right type of chocolate. It is best to use chocolate with a high cocoa content which is
specially produced for chocolate fondues/fountains. However, Belgian chocolate works just as well.
NOTE: Only switch the motor on if the chocolate is in a liquid state.
3. The easiest way to warm up the chocolate quickly is in a microwave oven. Break up the chocolate into
small pieces and microwave for approximately 60 to 90 seconds, depending on the microwave oven's
wattage.
4. Plug the unit to an earthed socket and turn the button to the 'HEAT' position to heat up the bowl of the
unit.
5. Pour in the melted chocolate and switch on the motor by turning the button to the 'HEAT MOTOR'
position.
6. We recommend adding half a teaspoon of cooking oil to the liquid chocolate to help it flow through.
7. After approximately 2 minutes switch off the motor for 1 minute and then switch it back on. This
should remove any air pockets. Now the chocolate should be flowing through nicely.
Note:
Do not turn off the heating element while the auger is in use, as this will cause the chocolate to solidify
and put strain on the motor. This could cause the unit to malfunction.
Never add any cold liquids to the chocolate while using the appliance.
CLEANING
MAKE SURE THE UNIT IS UNPLUGGED FROM THE ELECTRICAL SOCKET BEFORE CLEANING
1. Tip out any remaining chocolate from the bowl.
2. Wipe the bowl with kitchen paper, then clean with a damp cloth and dry completely.
3. Clean the auger and auger column thoroughly.
PRINCESS TIPS
- Never immerse the base of the unit in water or any other liquid.
- Do not use the unit in or near water.
- Never use abrasive cleaning agents.
- Never leave the unit unattended while in use.
- When not using the unit for a long period, please ensure it is disconnected from the main power supply.
- Never use the unit if the power cord is damaged. A damaged cord should only be replaced by our service
department using special tools.
- Keep the unit away from children.
- Do not place the unit on extremely hot surfaces.
- Always make sure that you read the user manual in full and understand the instructions for use.
- Children should be supervised to ensure that they do not play with the appliance.
- The use of this appliance by children or adults with a physical, sensory, mental or motorial disability,
or lack of experience and knowledge can be hazardous. Persons responsible for their safety should give
explicit instructions or supervise the use of the appliance.
- This appliance is not intended to be operated by means of an external timer or separate remote-control
system.
U.K. WIRING INSTRUCTIONS
The wires in the mains lead are coloured in accordance with the following code:
BLUE
BROWN
GREEN/YELLOW EARTH
As the colours of the wire in the mains lead of this appliance may not correspond with the
colour markings identifying the terminals on your plug, proceed as follows:
The wire which is coloured BLUE must be connected to the terminal which is marked with
the letter N or coloured black.
NEUTRAL
LIVE
4