Cross-Function; Call Up Several Chasers Continuously; Set All Channels To Maximum; Blackout-Mode - EuroLite CLX-16 Manual Del Usuario

If the chaser is to be run sound-controlled, press the Audio-button (Shift+Chase) and adjust the desired
sensitivity via the Audio-control.
If the chaser is to be run exactly in the bass-beat, pull Speed-control to minimum (the display shows "Sho")
and enter the bass-beats by pressing the Tap Sync-button repeatedly.
If the chaser is to be run step by step, press the Manual Step-button (Shift+Tap Sync) and press the Step
Up/Down-button repeatedly.

6.6 Cross-function

Via the Cross-function, you can call up the chaser step by step via the Masterfader.
Press the Cross Setup-button (Shift+Step Up). The Cross On LED is lit.
Push the Master-fader to maximum and press the Cross-button. Select the first step of the desired program
via the Pattern Up/Down-buttons (e. g. "11:01").
Turn the Level-control to maximum.
Push the Masterfader down and the second step will be called up (e. g. "11:02").
Press the Cross-button again in order to leave this mode.

6.7 Call up several chasers continuously

Via the Loop-function, you can run several chasers continuously.
The current chaser in the chase-mode is chaser 1.
Press the Loop-button and select the next chaser via the Pattern Up/Down-buttons.
Press the Loop-button, in order to add this chaser.
Press the Loop Exit-button (Shift+Loop).

6.8 Set all channels to maximum

Press the Full On-button and all channels will be set to their maximum value. As soon as you release the
button, the channels return to their original setting.

6.9 Blackout-Mode

Press the Standby-button and all devices will be set to Blackout-mode.

6.10 Footswitch

Connect your footswitch via the Foot Control-socket on the rearpanel. In this way you can select Full On or
Stand By.

6.11 Patching DMX-channels

In the Patch-mode, you can newly assign the channels individually. As an example, you can try to change
the channels 1-16 to 16-1.
Press and hold the Patch-button for approx. 1 second.
Press the Step Up/Down-Tasten, until the right two digits in the display show "01".
Press the Pattern Up/Down-Tasten, until the left two digits in the display show "16".
Now you have assigned channel 1 (old) to channel 16 (new).
Press the Step Up/Down-Tasten, until the right two digits in the display show "02".
Press the Pattern Up/Down-Tasten, until the left two digits in the display show "15".
Continue this procedure until you have assigned channel 16 (old) to channel 1 (new).
Press and hold the Patch-button for approx. 1 second in order to leave this mode.

6.12 Returning to the factory setup

Press and hold the Shift-button. Press the Latch-buttons 9, 13, 10, 14, 11, 15, 12 and 16. Let the Shift-button
loose.
20/35 70064650X89NXS_V_1_0.DOC