Assembly And Usage; Unpacking The Product - Joovy Nook NB Manual De Instrucciones

Assembly and Usage

Unpacking the Product

• Remove everything from the box – high chair, tray with tray insert, right aligner for tray and
documents (not shown).
• Discard all packaging materials properly, including plastic coverings.
• DO NOT allow children to play with any packaging materials.
I WARNING :
product. No tools required.
Unfolding the High Chair
• Keep children away from high chair while unfolding.
• Stand to the side of the folded high chair, hold the handle behind the seat and pull upward on the
seatback until it locks into its upright position. (1)
• Be careful not to pinch your fingers as the seat is raised.
• Place one foot on the rear frame bar and try to move the seatback back and forth to ensure it is
secure in its upright position.
Installing, Operating and Removing the Tray
• Before installing the tray, the right aligner must be installed onto the tray
• To attach this aligner to the tray, place the tray upside down on the floor or table. Also remove the
aligner from its packaging and place it open side up to the right of the tray. (2)
• Push the flat locking button on the right toward the right. (3A) and insert the rounded end of the
aligner into the slot. (3B)
• Push the aligner all the way in until it stops and then release the locking button to lock it in place. (4)
• The left aligner is already attached to the tray.
• To install the tray, turn it so that the tray surface is on top.
• With each hand, reach under each side of the tray and press the spring-loaded release buttons
upward. (5)
• Align the two tray aligners with the posts on the high chair and slide the tray onto these posts. (6)
• Slide BOTH sides of the tray all the way toward the high chair seatback as far as they will go and
then let go of the release buttons to lock it in place.
• Make sure both sides of the tray are positioned at the same distance from the seatback.
• Gently pull upward on the tray to ensure it is installed properly.
• To adjust the tray position, squeeze the spring-loaded release buttons under BOTH sides of the
tray and either push or pull the tray into the desired position. (7) Always ensure that BOTH sides of
the tray are positioned at the same distance from the seatback.
• To swing the tray open, squeeze the locking button under the right side of the tray ONLY and pull
the tray toward the front of the high chair. (8)
NOTE: The tray swing feature will not work properly if both sides of the tray are not at the same
distance from the seatback.
• To close the tray, gently swing the tray back toward the aligner. The tray will automatically lock
into position.
• Use caution when closing the tray with the child seated in the high chair.
• To completely remove the tray, squeeze the spring-loaded release buttons on BOTH sides of the
tray and pull the tray toward the front of the high chair.
4
Adult assembly is required for this