BEAUTY JATA DPC8B Instrucciones De Uso página 9

• Insensitive heat people must pay attention when using
this appliance.
• This appliance is designed fro domestic use only.
• The cleaning and maintenance done by users, can not
be done by children without any supervision.
• If the cable were to deteriorate it must be changed by
an Authorised Service Centre.
INSTRUCTIONS OF USE
• Plug the appliance to the mains.
• Remove the lid (1) and pour the wax in the tank 1.
• Turn the temperature selector 1 clockwise till the indication 90º. The indicator light 1 will light
on and the appliance will start working.
• The temperature selector 2 must be in off position "0".
• Move the wax with the spatula (9). Make sure the melted wax do not over the middle of the tank.
• When the wax is melted set the temperature selector 1 between 55-60º. You can adjust it having
in mind your own heat sensitivity.
• Mix properly the wax to get a uniform temperature.
• Before starting with the depilation use the spatula (9) and pour a little bit of wax in the back of
your hand so you can check if the wax temperature is the correct one for you.
• Put your hand in the area to be waxed in a counter direction of hair growth.
• Use the spatula (9) and extend the wax in areas about 3-4 cm wide anb about 6-8 cm long. The
wax must always be applied in the counter direction of hair growth.
• Wait a while for the wax cool slightly, but do not wait till dry it.
• If it is not stick when touching it, push with the hand and pull firmly.
• Place the filter (8) in the tank 2 and place in it the used wax.
• Set the temperature selector 2 in the 90º indication. When the wax is melted, you can filter it,
remove the filter and place it under cold water.
• In this way you can continue using the wax of the tank 2 and placing the filter in tank 1 where
you can put the used wax.
• Once finished the depilation set the temperature selectors to the "0" position and disconnect the
appliance from the mains.
• Finally it is advisable to apply a moisturizer cream.
MAINTENANCE AND CLEANING
• Before you proceed to cleaning the appliance ensure the appliance is unplugged from the mains.
• The remaining wax around the outside of the appliance can be removed with your nail once dried.
• The exterior parts may be cleaned with a slightly dampened cloth.
• Do not use abrasive or chemical products, metallic scourers, which may deteriorate the surfaces
of the appliance.
9