SSP MRP101 Manual De Instrucciones página 7

Templet guide (optional accessory)
004932
The templet guide provides a sleeve through which the
bit passes, allowing use of the tool with templet patterns.
To install the templet guide, loosen the screws on the tool
base, insert the templet guide and then tighten the
screws.
3
003692
Secure the templet to the workpiece. Place the tool on
the templet and move the tool with the templet guide
sliding along the side of the templet.
1
2
3
4
5
6
003695
NOTE:
The workpiece will be cut a slightly different size
•
from the templet. Allow for the distance (X)
between the bit and the outside of the templet guide.
The distance (X) can be calculated by using the
following equation:
Distance (X) = (outside diameter of the templet
guide - bit diameter) / 2
1. Templet guide
1
2. Screw
3. Base plate
2
1. Bit
7
2. Base
3. Templet
4. Workpiece
5. Distance (X)
6. Outside
diameter of the
templet guide
7. Templet guide
Trimmer guide
1
004935
Trimming, curved cuts in veneers for furniture and the
like can be done easily with the trimmer guide. The guide
roller rides the curve and assures a fine cut.
Install the trimmer guide on the guide holder with the
wing bolt (B). Insert the guide holder into the holes in the
tool base and tighten the wing bolt (A). To adjust the
distance between the bit and the trimmer guide, loosen
the wing bolt (B) and turn the fine adjusting screw (1.5
mm or 1/16" per turn). When adjusting the guide roller up
or down, loosen the wing bolt (C). After adjusting, tighten
all the wing bolts securely.
1
2
3
4
5
004936
When cutting, move the tool with the guide roller riding
the side of the workpiece.
3
003701
7
1. Trimmer guide
1. Wing bolt (A)
2. Guide holder
3. Fine adjusting
screw
4. Wing bolt (B)
5. Wing bolt (C)
6. Guide roller
7. Trimmer guide
6
7
1. Bit
1
2. Guide roller
3. Workpiece
2