Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
installation guide
Always use two people when setting up the base, moving or flipping the base.
STEP 1
Place the bed base box in a desired location with the bottom of
the box facing up.
Remove the binding straps and packing materials, making sure
not to puncture the box with any sharp objects.
STEP 2
Remove the bed base from the box keeping the bottom of
the base facing upwards.
If installing a Divided King, please refer to Divided King
STEP 3
To install headboard brackets,
see instructions on page 16 and 17
To install the legs, thread the washer over the screw on the leg.
Next, screw the leg into the nutsert on the frame. Do not over
tighten.
For customer support, visit www.ergomotion.com or call: 1-888-550-3746
10
Installation Guide
STEP 4
To sync two bases with the SmartSync™ cord - see page 15
Uncoil the Power Down Box from the frame
and place the box on the ground. Ensure
that it is easily accessible when the base is
turned to its upright position.
STEP 5
Uncoil input cord (connected to control box's
power port) and plug into Power Supply.
STEP 6
Uncoil the Power Cord and connect to the
Power Supply. Place Power Supply on the
ground and extend from the base. Ensure
that the Power Supply and all attached
cords are directed toward the desired
surge protector.
Publicidad
Tabla de contenido
