Dimensions And Format Of Suitable Diamond Slitting Discs; Preparations At The Workplace - Hilti DCH 150­SL Manual De Usario

Noise emission values
Emission sound pressure level (L
Uncertainty for the sound pressure level (K
Sound power level (L
WA
Uncertainty for the sound power level (K
Total vibration
Vibration emission value (a
Uncertainty (K)
4.3

Dimensions and format of suitable diamond slitting discs

Diamond slitting discs must meet the following require-
ments in terms of dimensions and format.
Technical data
Slot width between segments
(G)
Cutting angle
5

Preparations at the workplace

CAUTION
Risk of injury! Inadvertent starting of the product.
▶ Unplug the supply cord before making adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1 Installing diamond slitting discs
Pin wrench
@
Clamping nut
;
Spacer ring
=
Diamond slitting disc
%
1. Lay the tool on its left side (spirit level facing up).
2. Press and hold down the carriage release button to unlock the carriage.
3. Swing the carriage out and let go the carriage release button.
4. Fit the clamping flange onto the spindle.
5. Place the first diamond slitting disc on the clamping flange. Make sure that the direction-of-rotation arrow
on the slitting disc points in the same direction as the direction-of-rotation arrow on the power tool.
Comply with the instructions for selecting suitable diamond slitting discs. → page 20
6. Select the correct spacer rings for the width of the slit and place them on the clamping flange.
The width of the slit is equal to the thickness of the two diamond slitting discs and the spacer rings
inserted between them. The widths of the spacer rings are 4 mm, 7 mm, 13 mm and 22.5 mm.
7. Place the second diamond slitting disc in position.
WARNING
Risk of injury! The diamond slitting discs can work loose in operation if the complete set of spacer rings is
not installed on the clamping flange.
▶ After installing the second diamond slitting disc, always place all the remaining spacer rings on the
clamping flange.
20 English
)
pA
)
pA
)
)
WA
)
h
≤ 15 mm
Negative
2
Clamping flange
&
Arbor (on the slitting tool)
(
Direction-of-rotation arrow on casing
)
2208335
*2208335*
94 dB(A)
3 dB(A)
105 dB(A)
3 dB(A)
4.6 m/s²
1.5 m/s²