Publicidad
Idiomas disponibles
Idiomas disponibles
English
Operating Process
1. Water is pumped from the water storage tank to the water box, which may
take up to 1 minute.
2. The icemaking cycle begins when the evaporator rods are dipped into the
water box. You will hear the compressor working.
3. It will take approximately 6-13 minutes for each icemaking cycle, depending
on the size selected & room temperature. The larger the size or higher room
temperature, the more time is needed to make the ice. After the cycle is
finished, the water box will tilt forward and the remaining water will flow
back into the water storage tank. The evaporator rods will then release the ice
cubes.
Note: If the room ambient temperature is below 60˚ F, then small ice cube
sizes are suggested to prevent ice cubes from fusing together.
4. Approximately 15 seconds later, the water box will tilt backwards and the ice
pusher will push the ice into the ice storage basket. After the water box flips
back to its original position, the next icemaking cycle will begin.
5. When the maximum capacity of ice cubes is collected and the ice obstructs
the infared sensor, the icemaker will automatically stop operating. The "ICE
FULL" LED indicator will light up.
If more ice is needed, remove the ice from the ice storage basket; then
replace the basket into the machine, making sure that the basket is placed
back to its original position. Note: When replacing the basket, ensure that the
infared sensor is not obstructed by the basket so that the machine operates
properly.
WARNING! Direct or reflected sunlight may cause the infrared sensor to
6. To continue making ice, check that there is water in the water storage tank. If
there is no water in the water storage tank, then no water will be pumped into
the water box, and the operation will stop. The "Add Water" LED display will
light up. Press the "OFF" button. Fill the water storage tank with water, and
then press the "ON" button for the icemaker to begin operating again. Allow
the refrigerant inside the compressor at least 3 minutes to settle before
restarting.
7. If the compressor stops for any reason such as water shortage, too much ice,
power off, etc., do not restart the machine right away.
Wait at least 3 minutes before restarting the machine.
9
malfunction. If the unit doesn't stop, even with ice cubes
obstructing the sensor, move the unit out of the sunlight.
Publicidad
