Fault Codes - Electrolux FFRE1833U2 Uso Y Cuidado

Operating Instructions
(continued)
REMOTE SENSING FEATURE
(on some models)：
SENSING BUTTON
Note: This feature can be activated from the remote control ONLY, the unit must be in cool/eco mode.
To activate the remote sensing feature, point the remote control towards the unit and press the remote sensing button. Next, use
the " " buttons to set the desired temperature at the remote. (Note that the set temperature will only be displayed on the unit
itself ). The signal icon on the remote control will pulse each time it sends a signal. lt will periodically send this signal until the feature
is deactivated by pressing the remote sensing button. lf the unit does not receive the remote sensing signal during a maximum of 200
seconds interval, the unit will end remote sensing mode automatically.
The display on the remote control indicates the temperature at the remote ONLY.
NOTE: The Remote Sensing function is terminated either by using the Remote Sensing button or the main ON/OFF button on the unit.

FAULT CODES:

If the display reads "AS", a sensor has failed. Contact your
Authorized Frigidaire Service Center.
If the display reads "CS", a sensor has failed. Contact your
Authorized Frigidaire Service Center.
TO CHANGE TEMPERATURE UNIT DISPLAY:
DO THIS:
PRESS AND HOLD THE
UP/DOWN BUTTONS
TOGETHER FOR 3 SECONDS
2 0 0 9 E e l t c o r u l x H o m e P
DO THIS:
PRESS REMOTE
NOTE: Unit display shows the set temperature
o r d u t c , s n I . c
Operating Instructions
LIGHT pulsing ( On & Off intermittently ).
If the display reads "ES", a sensor has failed. Contact your
Authorized Frigidaire Service Center.
YOU WILL SEE:
Note: The control is capable of displaying temperature in
degrees Fahrenheit or degrees Celsius.
NOTE: Remote display
is actual temperature
at remote control only
l A r l g i h s t r s e r e e v . d 9