En - User Guide - NORAUTO L11 Instrucciones De Uso

Your Group 1-2-3 booster seat
(2)
1. Adjustable headrest
2. Harness straps (x2)
3. Folding armrest (x2)
4. Shell
5. Adjustment strap (x2)
6. Crotch strap
7. Harness buckle
8. Adjuster (x2)
9. Reducer cushion (if fitted on this model)
10. Safety cover (x2)
11. Diagonal belt guide (x2 - used without the harness)
Installation with the harness
Gr. 1, from 9 to 18 kg (from approximately 9 months to 4 years)
Make sure that the harness of your car seat is adapted to the height of your child before start-
ing to install the seat in your car.
The harness can be adjusted to three different heights. The straps must pass through the holes
that are closest to your child's shoulders. If your child's shoulders are between two levels, al-
ways use the higher of the two. To adjust the height of the harness, remove the upper section
of one of the harness straps by twisting the metal keeper located behind the backrest (3) and
then pulling the end of the harness strap through the slots of the shell and the cover (4). Feed
the end of the harness strap through the same slots at the desired height, both in the cover
(5) and reattach it behind the backrest (6). Make sure that the metal anchor is
and the shell
correctly positioned and that the end of the harness strap is not twisted. Repeat the operation
on the second strap.
• To tighten the harness: Pull on the adjusting straps positioned on the harness. You do not
need to press on the adjuster buttons (7).
• To loosen the harness: Press on the adjuster buttons positioned on the upper section of the
harness, grasp the lower section and pull simultaneously (8). Press on the red harness button
on the buckle to free your child completely.
Place the car seat against the back seat of the vehicle (9). Lower the headrest as far as possible.
Pull on the vehicle seat belt until it is completely loose. Feed both straps of the belt through
the openings in the cover and the backrest shell (10) making sure the waist strap passes un-
der the arm rest of the car seat and that the diagonal strap rises vertically between the back-
rest and the head support without passing through the belt guide. Bring the vehicle belt out
through the opposite openings (11). Make sure that the waist strap of the belt passes under
the arm rest and that the diagonal strap passes above the arm rest of the car seat. Fasten the
vehicle seat belt, making sure that it is not twisted (12). Push the car seat firmly against the
back seat of the vehicle and tighten the belt as much as possible by pulling the waist strap and
the diagonal strap towards the winder (13). Open the harness buckle by pressing on the red
button in the centre of the buckle. Place your child in the car seat. The folding armrests make
it easier to install and access the car seat. Put the harness buckle ends together and close the
buckle, making sure you hear a 'click' (14). Pull on the adjusting strap of one of the upper har-
38

EN - User guide