Heiniger C12 Manual De Instrucciones página 25

Motor Section
MALFUNCTION
Motor does not run
Motor runs very slowly
Runing time of a charged batterie
is too short and/or motor gets
hot
Instruction manual C12
CAUSE
Storage battery empty
Terminal clamps are loose (Illust-
ration 1, Item 25)
Smell of burning from the
motor housing. Motor burned
out
Switch without contact
Machine jams because of wron-
gly or reverse connected terminal
clamps
Storage battery empty
Wrong type of storage battery
Clipping tension too high and/or
clipper blades are blunt
Blades and clipper head were
inadequately oiled
Air filter blocked
Flat, wrong or too small storage
battery being used
Faulty storage battery
RECTIFICATION
Charge storage battery
Switch off machine (Switch to 0)
and secure terminal clamps
Have motor replaced
Have switch replaced
Have machine repaired by
specialist workshop
Charge storage battery
Only use 12V lead storage batte-
ries with a min. of 45 Ah
Reduce clipping tension
(Illustration 6)
Have blades resharpened
Oil blades and clipper head (Illus-
tration 4)
Clean or replace air filter
Use fully charged, 12V lead
storage battery with a min.
of 45 Ah
Replace storage battery
13