Cleaning - Heiniger Saphir F Instrucciones De Uso

Fig. 22
CAUTION!
Remove all the leaking, used up or excessive grease from all the lubrication
points, and it is to be disposed in accordance with the local regulations.

6.2.5 Cleaning

To receive good clipping results and to increase the durability of the clipper
and the clipperhead, it is necessary to apply a thin oil coat between top and
bottom blade (6.2.4 Lubrication).
Clipperhead and hinge
Clean clipperheads und hinge between the different clippings.
Charging station
Fig. 23
Contacts
Clean the contacts of the battery and the shearer with a dry cloth as nec-
essary.
NOTE!
If not using daily, store shearer and charging station in the packaging sup-
plied with them. When in use daily, we recommend to put clipper and re-
serve battery in the charging station.
16
The blades must be oiled before,
during and after every use. When
the blades of the clipper are leav-
ing stripes or are running with re-
duced speed, this is a signal that oil
is required. Place a few drops of oil
ahead and laterally on the clipper
blades (see arrows in fig. 22). Wipe
off the excessive oil with a smooth,
dry cloth. Lubrication sprays do not
have sufficient oil for a good lubri-
cation, but serve for cooling the
blades. Immediately change dam-
aged or crenated blades to avoid
injuries.
1. Disconnect the charging station
from the power supply.
2. If necessary, take away hairs
from both charging cavities.
3. If required, clean the contacts (1)
and (2) with a dry cloth.
Instruction Manual / Small animal clipper