HIKOKI C 5MEY Instrucciones De Manejo página 6

English
MOUNTING AND OPERATION
Action
Inclined cutting using the guide
(+45° direction)
Fine tuning of parallelism
Fine tuning of perpendicularity
Fine tuning of guide piece position
Adjusting the cutting depth
Cutting line
Switch operation
About the mode select function
Using the LED light
Using the cord holder
Attaching the guide (sold separately)
Attaching the fl uorine plate
(sold separately)
Attaching the dust collection adapter
(sold separately)
Attaching the hook *
( 2)
(sold separately)
Cutting at right angles
Inclined cutting (+45° direction)
Dismounting the saw blade
Mounting the saw blade
Holding the tool
Selecting accessories
(*1) About the mode select function
Each time the mode selector switch is pushed, the
operation mode changes.
When Silent mode is selected, the Silent mode indicator
lamp lights up.
Silent mode reduces maximum motor RPM enabling
effi cient work with less noise.
Safeguard Function
Overload Protection
Temperature Protection
Figure Page
9 157
10 157
11 158
12 158
13 158
14 158
15 158
* 16 158
( 1)
17 159
18 159
19 159
20 159
21 159
22 160
23 160
24 161
25 161
26 162
27 162
― 163
LED Light Display
On 0.1 second/off 0.1 second
On 0.5 second/off 0.5 second
If the load increases while the motor is operating in
Silent mode, it automatically changes to Power mode.
Additionally, if the load decreases again, it automatically
returns to Silent mode.
In Power mode, no change is made to Silent mode even
when the load decreases.
Mode
Power
Silent
NOTE
○ You cannot change the mode unless the power plug is
connected to a receptacle and the switch is pulled once.
○ Even if the switch is turned on and off or the power plug
is disconnected and connected, this unit will maintain the
mode that you set.
(*2) Attaching the Hook
The hook can be used to hang up the unit temporarily
during operations (Fig. 22).
CAUTION
The hook should never be used to hang the unit on your
person.
When using the hook, check to make sure that the main
unit will not slip and fall, or become unstable by the wind,
etc.
Never hang the unit from your belt or trousers as this
could cause accidents.
LED LIGHT WARNING SIGNALS
(Fig. 28)
This product features functions that are designed to protect
the tool itself. While the switch is pulled and 3 seconds after
its release, if any of the safeguard functions are triggered
during operation, the LED light will blink as described in
Table 1. When any of the safeguard functions are triggered,
immediately remove your fi nger from the switch and follow
the instructions described under corrective action.
Table 1
Remove the cause of the overloading.
Allow the tool to thoroughly cool.
6
No-load speed
5000 min
-1
2500 min
-1
Corrective Action