JVC AA-V100U Manual De Instrucciones página 3

A WORD ON THE EXCLUSIVE BATTERY PACKS
The battery packs are lithium-ion.
Give attention to the following to make the most of
their characteristics.
For charging : 10°C to 35°C (50°F to 95°F)
For operating : 0°C to 40°C (32°F to 104°F)
For storing : –10°C to 30°C (14°F to 86°F)
NOTE:
The rating plate (Serial number plate) is on the
bottom of the unit.
USING HOUSEHOLD AC PLUG ADAPTER
In case of connecting attached Power Cord Plug to
AC wall outlet other than American National
Standard C73 series type, use an AC plug adapter,
so called "Siemens Plug", as shown below.
For this AC plug adapter,
consult your nearest
JVC dealer.
This Class B digital apparatus complies with
Canadian ICES-003.
Cet appareil numérique de la classe B est conforme
à la norme NMB-003 du Canada.
Plug adapter (optional)
INFORMATION
This device complies with Part 15 of FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that may
cause undesired operation.
Change or modifications not approved by the party
responsible for compliance could void the user's
authority to operate the equipment. This equipment has
been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV
technician for help.
EN-3