EIBENSTOCK EPG 400 WP Instrucciones De Servicio página 16

the electronic switch when you want to start the machine slowly for a optimal
surface.
Permanent use with reduced speed can cause an overload because the
motor then gets less cooling air and therefore the machine will be
overheated much faster.
Attention!
Before the beginning of all works disconnect the plug
from the mains!
Mounting the base plate:
Place the base plate onto the head spindle and secure it with the help of the
provided screw.
Mounting the work disk:
Place the work disc centrally onto the Velcro plate.
The entire disk must cling to the Velcro plate to ensure that the disk is
attached securely.
Attention!
Before you start working, check whether the accessory has the exact
position. Let the machine start running in a safe position for a short
time. In case the machine does not run easily, immediately stop
working.
Connect the tool to the water supply system
or a water tank using the GARDENA
connector.
Please use a GARDENA hose coupling as
connecting piece to the machine. The hose
coupling is available on the market.
Only use clear tap water.
Tool Change
Water Supply
16