SOMFY SITUO 5 io/RTS Manual De Instalacion Y Uso página 22

3 PROGRAMMING YOUR REMOTE CONTROL ON SOMFY
EQUIPMENT
3.1 Programming on a Somfy remote-controlled lamp holder or socket
Adding a remote control (B) using a remote control already programmed (A)
1. On the 5-channel remote control A, select the channel which controls the products you want to add to remote
control B : press the channel selection button already programmed as many times as necessary .
2. Use a fine-tipped object to press the PROG button on the back of this same remote control A. The indicator
lights on the associated devices will flash.
3. On 5-channel remote control B, press the channel selection button as many times as necessary until the
indicator lights show the channel to be added.
4. Use a fine-tipped object to press the PROG button on the back of this same remote control B. The indicator
lights on the devices to be linked come on permanently, then go out. The channel is programmed on the new
remote control B.
5. If necessary, repeat this procedure with the other channels on remote control A.
1
Remote control already programmed
This procedure requires a good knowledge of your installation.
For example, to add 2 roller shutters paired with channel 1 of remote control
you have already programmed one of these 2 roller shutters on channel 5 of remote control B, the shutter already
programmed will be deleted and the shutter not already programmed will be added.
We therefore advise you to add your products little by little with an individual control to avoid any deprogramming
error.
6 EN - Installation and operating guide for io / RTS centralisation remote control - SOMFY
2
< 0.5 s
(A)
3 4
New remote control
A to channel 5 of remote control B, if
< 0.5 s
(B)