DeLOCK Pen Scope Manual Del Usuario página 3

Note:
Follow the general instructions for installation of the USB device. If necessary,
read the manual of your computer, or ask a specialist for help.
Driver Installation
Windows Vista
1. Switch on your computer.
2. Connect the USB cable with an available USB port of your computer.
3. Put the driver CD in the CD ROM drive.
4. Afterwards, Windows displays the Hardware wizard.
5. Choose "Don´t show this message again for this device".
6. Open Windows Explorer, select: CD-drive\PenScope\Setup.exe.
7. Choose your language and click "Next".
8. Click on "Next".
9. Choose "Install the driver software anyway".
10. Click on "Finish", to restart the computer.
11. After restart you can start the Software "Toprocap", and you can use the
device.
Windows XP/2000
1. Switch on your computer.
2. Connect the USB cable with an available USB port of your computer.
3. Put the driver CD in the CD ROM drive.
4. Afterwards, Windows displays the Hardware wizard. Click on "Cancel".
5. Open Windows Explorer, select: CD-drive\PenScope\Setup.exe.
6. Choose your language and click "Next".
7. Click on "Next".
8. When driver is located, click "Continue installation".
9. Click on "Finish", to restart the computer.
10. After restart you can start the Software "Toprocap", and you can use the
device.

- -