Publicidad
Idiomas disponibles
Idiomas disponibles
Battery Compartment
Cover
This way you receive results that are as accurate as possible:
A)
Wait at least 15 minutes after your last sip of alcohol.
Do not eat, drink or smoke during that time.
B)
Do not open the casing.
C)
Do not keep the breathalyzer in cold, hot, moist or badly
ventilated places.
D)
Keep the breathalyzer out of the reach of children.
E)
Conduct three inlet tests after long storage before conduc-
ting the actual alcohol test.
F)
Do not drop the breathalyzer.
G)
Change the battery if it is depleted. Diminished battery
capacity leads to incorrect test results.
H)
Do not conduct tests in loud (sound waves disrupt the
sensor), drafty or poorly ventilated places.
I)
After a test result of 1.000‰ (per mill = default setting) or hig-
her the sensor needs rest time. In this case wait at least three
minutes before the next test.
J)
Do not conduct tests in very cold, very hot or an unventilated,
smoky ambience.
Store the breathalyzer in a way to avoid penetration
K)
by dust or liquids.
L)
Blowing too hard may cause damage to the sensor as saliva
flows into it.
ACE INSTRUMENTS RECOMMENDS:
ALWAYS USE A NEW MOUTHPIECE FOR EACH PERSON AND
TEST THAT IS CONDUCTED. ACE INSTRUMENTS ASSUMES NO
LIABILITY FOR ANY DAMAGES WHICH ARISE WHEN SEVERAL
PEOPLE USE THE SAME MOUTHPIECE FOR MULTIPLE TESTS.
Hand Strap
HYGIENIC MOUTHPIECES - MORE ARE AVAILABLE AT
Air Outlet
WWW.ACE-INSTRUMENTS.NET.
(always keep
this part
unblocked)
AND EXTERNAL PARTS COME INTO CONTACT WITH HUMAN
SECRETION (SALIVA, BLOOD, SWEAT, ETC.)! USE DISPOSABLE
GLOVES WHEN PULLING OUT A MOUTHPIECE USED BY
ANOTHER PERSON! YOU CAN BUY APPROPRIATE GLOVES
E.G. AT ACE TECHNIK (WWW.ACE-TECHNIK.DE).
Preparation for the test:
1.
small paper inside the battery compartment which prevents
the battery from discharging. Open the battery compartment
cover at the back of the device (push it downwards), pull out
the paper and close the battery compartment cover again. If
you exchange old batteries against new ones please mind the
battery polarity (+/- pole).
2.
Ensure whether it securely fits or not. For sanitary reasons it is
highly recommended to use an extra mouthpiece for each test.
Conducting the measurement:
1.
beep sound.
2.
countdown starts.
3.
nally the device beeps twice). As soon as you can see "blow",
start blowing into the mouthpiece. The device will start beeping
when you start blowing. Keep blowing steadily until the bee-
ping stops. At the end of the test you can hear a "tic-tac" tone.
Tip: Blow like you would whistle (without a break).
4.
4 digit readout of your blood alcohol level in ‰ (per mill = EU
setting) OR 0.050 mg/L (= UK setting) OR % BAC (= US setting).
The accuracy of this device is of +/- 0.10‰ (per mill = default
setting) with reference to 0.50‰. For devices with UK mea-
surement unit the tolerance is +/- 0.05mg/L with reference to
0.25mg/L, for devices with US measurement unit the tolerance
is +/- 0.01% BAC with reference to 0.05% BAC.
5.
ONLY USE THE PROVIDED SINGLE PACKED AND
DURING EACH TEST THE BREATHALYZER´S INTERNAL
If you use the device for the first time you have to remove the
Insert a mouthpiece into the slot on the side of the breathalyzer.
Push the power button* for about 2 seconds until you hear a
After pushing the power button the device warms up and a
After a few seconds you see "blow" on the display (additio-
The test result is displayed after a few seconds. It shows a
The device puts itself off automatically approx. 15 seconds
Publicidad
