5.2 Control, care and inspection
Allow the product to cool down to room tempera-
ture.
Inspect the product after each cleaning and disin-
fecting cycle to be sure it is: clean, functional, and
undamaged.
Lubricate the shearing head as appropriate, see
section Lubricating the shearing head.
To enhance the cutting power, adjust the plate
pressure as required, see section Adjusting the
plate pressure.
Check the product for any damage, abnormal run-
ning noise, overheating or excessive vibration.
Inspect the shearing head for broken, damaged or
blunt cutting edges.
Set aside the product if it is damaged.
6.
Maintenance
To ensure reliable operation, Aesculap recommends
servicing the product at least once a year.
Service addresses
Albert Kerbl GmbH
Felizenzell 9
84428 Buchbach / Germany
Phone:
+49 (0) 8086 933-100
Fax:
+49 (0) 8086 933-500
E-Mail:
info@kerbl.com
www.kerbl.com
Other service addresses can be obtained from the
address indicated above.
7