MESTO VERIS 3237 Instrucciones De Uso página 16

GB IRL
1. Pull up the red button on the piston pressure gauge [9] until all excess pressure is
released from the tank (Fig. 5)
2. Press the piston rod with handle [10] down and turn it counterclockwise
► The piston rod with handle is locked. (Fig. 6)
3. Unscrew the pump [2] from the tank. (Fig. 7)
+
We recommend you mix the spraying liquid in the device or premix it in an external
tank: Fill to 1/3 with water, pour in the spraying agent, and then add more water
until full.
4. Add the spraying liquid to the tank [1] (Fig. 8)
5. Check the filling level with the scale [11] on the tank. (Fig. 8)
6. Screw the pump [2] into the tank. (Fig. 9)
7. Press the piston rod with handle [10] down and turn it counterclockwise. (Fig. 10)
► The piston rod with handle is unlocked. (Fig. 10)
8. Generate the desired pressure (→ Table 2) in the tank (Fig. 11).
+
The maximum pressure should not exceed 3 bar (red line on the piston pressure
gauge, Fig. 10). If the maximum pressure is exceeded, the safety valve will engage
and release the excess pressure.
9. Press the piston rod with handle [10] down and turn it counterclockwise (Fig. 6)
► The piston rod with handle is locked.
Spraying
Observe the instructions in the section entitled „Safety".
Operate the device only while it is vertical or suspended upright and nearly
vertical.
Avoid allowing drops of spray to drift onto areas that are not being treated.
Observe the instructions of the spray product manufacturer!
1. Hang the device over your shoulder. (Fig. 12)
+
To prevent dripping, hold the spray wand up when first spraying and activate the
shut-off valve until no more liquid mixed with air is emerging from the nozzle.
2. Activate the shut-off valve [5] (Fig. 13)
► Spraying may now begin.
3. Make certain the optimum spraying pressure is set (→ Table 2) on the piston pressure
gauge [9] (Fig. 12).
Spraying pressure
1.5 bar (21.76 psi)
2.0 bar (29 psi)
3.0 bar (44 psi)
Table 2. Linear dependence: spraying rate and spraying pressure
4. If the spraying pressure decreases more than 0.5 bar from the optimum level, pump
some more.
+
If liquid mixed with air emerges from the nozzle, the tank is empty.
AUS USA
Spray quantity for hollow cone nozzle
16
NZ
0.49 l/min (0.13 gal/min)
0.56 l/min (0.15 gal/min)
0.69 l/min (0.18 gal/min)
CDN IND