Delta AP-100 Manual De Instrucciones página 11

LIGHT STARTER
NOTE: The starters supplied with this machine are standard fluorescent starters (fs-2).
Disconnect unit from the power source!
1. To remove the starter (A) Fig. 11, turn the starter (A) counter clockwise until it stops. Pull the starter out.
2. Insert a new starter by aligning the two prongs (B) Fig. 12 with the two holes (C) in the starter holder. Turn the starter
clockwise until it stops.
A
Fig. 11
KEEP THE UNIT CLEAN
Periodically blow out all air passages with dry compressed air. All plastic parts should be cleaned with a soft damp
cloth. NEVER use solvents to clean plastic parts. They could possibly dissolve or otherwise damage the material.
Wear certified safety equipment for eye, hearing and respiratory protection while using compressed air.
FAILURE TO START
Should your unit fail to start, check to make sure the prongs on the cord plug are making good contact in the outlet.
Also, check for blown fuses or open circuit breakers in the line.
C
Fig. 12
11
11
B