Install The Battery Cover; Set Up The Lock; Test The Lock; Extend The Bolt (Lock) Using The Inside Thumbturn - Schlage CONNECT Guia De Instalacion

9b Install the battery cover.
10

Set up the Lock.

1. Open the door if it is not already open.
2. Press the Outside Schlage Button.
3. Enter one of the Default User Codes into the
lock (see step 5 on page 5).
4. The lock will perform a setup routine. Wait until
the bolt stops moving before continuing.
L If the Touchscreen did not light up during this
step, you may have a power problem. Install
fresh batteries and make sure the battery wires
are connected (see step 9a on page 11).
If that does not help, make sure the cable is
connected and is not crimped (see step 8b on
page 10).
11

Test the Lock.

CAUTION
Keep the key with you
during testing to avoid
being locked out!
11a Extend the bolt (lock) using the inside thumbturn.
1. Close the door.
2. Rotate the thumbturn toward the door jamb to extend the
bolt.
YES
Continue to
step 11b.
12
L For complete information about programming
Was this operation smooth?
You may need to adjust your door/
frame. Continue to step 11b for
further testing, or go to answers.
schlage.com and watch the video
Proper Alignment of Door and
Frame for a Smoothly Operating
Lock for adjustment instructions.
Speaker Hole
DO NOT install screw!
and light/beep patterns, see the Programming
the Touchscreen and Troubleshooting
sections in the User's Guide.
NO