Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
•
If the spring is out of tension, it must be replaced.
Slide out spring from the dimple. Contact your near-
est Sears store or service center for replacement.
•
Replace new spring so that the short arm of the
spring is inside the hole on the body.
•
Position blade guard so that the long arm of the
spring is against the wall of the blade guard.
•
Secure blade guard using pan head screw and
washer.
•
Make sure blade guard functions appropriately.
REPLACING
TIMING
BELT
Refer to Figures 21 and 22.
•
Turn the switch to "OFF" position and unplug the tool
from power source.
•
Lay the jointer/planer on the side so that the switch
faces the roof.
•
Remove old timing belt by turning belt and maintain-
ing pressure.
Figure 21 - Removing Timing
Belt
•
Replace with new timing belt by maintaining inward
pressure.
Replace
Figure 22 - Replacing Timing
Belt
NOTE: Make sure that the full width of belt is on both
pulleys.
GENERAL
MAINTENANCE
Jointer/planer
will operate best if it is kept in good oper-
ating condition. Keep unit adjusted as described in
"Operation."
•
Do not allow gum and pitch to accumulate on the
tables, fence, blades and blade guard.
•
Apply a thin coat of paste type wax to the tables and
the fence so that the wood slides easily while feed-
ing.
•
Do not allow chips to accumulate on the underside
of the jointer/planer.
Keep blades sharp (see "Sharpening Blades," page
9). Sometimes replacing blades is less expensive
than resurfacing them. Keeping a spare set of blades
on hand is recommended. Blades should always be
sharpened or replaced in sets of two.
LUBRICATION
WARNING:
Make sure the switch is in the "OFF" posi-
tion and the tool is disconnected from the power
source.
WARNING:
Do not at any time let brake fluids, gaso-
line, penetrating oils, etc. come in contact with plastic
parts. They contain chemicals that can damage and/or
destroy plastics.
•
Motor and cutterhead bearings are sealed and need
no lubrication.
•
Fence guide and elevation screws should be cleaned
of debris and greased as needed.
MACHINED
SURFACES
•
Surface of tables and fence must be kept smooth and
clean for easy work feed.
•
Apply a paste wax to surfaces to keep them slick
and prevent corrosion.
10
Publicidad
Tabla de contenido
