Publicidad
Idiomas disponibles
Idiomas disponibles
SC1000R I.S 325-1439
ST-A, STO, STO-A, SJ, SJ-A, SJO, SJO-A, SJT-A, SJTO, OR
SJTO-A.
• This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Under Part 15 of the FCC Rules, any changes or modifications to the
motion detector described in this instruction sheet that are not
expressly approved by Cooper Lighting could void the user's authori-
ty to operate the equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equip-
ment generates, uses and can radiate radio frequency energy and if
not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular
installation.
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRIC
SHOCK, EXPOSURE TO EXCESSIVE UV RADIATION, OR
INJURY TO PERSONS
Lighted lamp is HOT!
To reduce the risk of FIRE, ELECTRIC SHOCK, EXPOSURE
TO EXCESSIVE UV RADIATION, OR INJURY TO PERSON:
• Do not block any ventillation openings. Install in accordance with the
manufacturer's instructions.
• Unplug and allow to cool before replacing bulb.
• Bulb gets HOT quickly! Only contact switch/plug when turning on.
• Do not touch hot lens, guard, or enclosure.
• Do not remain in light if skin feels warm.
• Do not look directly at lighted bulb
• Keep bulb away from materials that may burn.
• Use only a 500 watt, or lower wattage halogen type "T" bulb. Use of
any other bulb will damage the fixture and void the warranty.
Installing a higher wattage bulb could create a fire hazard.
• Do not touch the bulb at any time. Use a soft cloth or gloves. Oil from
skin may damage bulb.
• Risk of exposure to excessive ultraviolet (UV) radiation. Do not oper-
ate unit with a missing or damaged guard, lamp containment barrier
or UV filter.
• Do not direct light at persons.
• Fixture must be connected to a 120 Volt, 60 Hz power source. Any
6/4/04
4:12 PM
Page 3
SAVE THESE INSTRUCTIONS
3
Publicidad
