Interruption Of Work; Taking Out Of Operation And Cleaning - Earlex Spraystation HV2901 Manual De Instrucciones

HV2901/3901/5901
Fig. 7 A / 7 B:
Fig. 7 C:
•
Move the spray gun evenly side to side or up-and-down, depending on the spray
pattern setting.
•
An even movement of the spray gun results in an even surface quality.
•
When coating material builds up on the nozzle and air cap, clean both parts with a
solvent or water.
"Cross spray" when using paint with a poor covering capacity or if the
i
surface is highly absorbent (Fig. 8).
Interior wall paint in strong colour shades should be applied at least twice.
i
This will ensure good coverage.

14. Interruption of Work

Turn the tool OFF.
•
During longer breaks, vent the container by briefly opening and then closing it again.
•
Clean nozzle openings after an interruption in operation.

15. Taking Out of Operation and Cleaning

Proper cleaning is the prerequisite for problem-free operation of the paint application
device. No guarantee claims are accepted in case of improper or no cleaning.
1) Unplug the tool. Vent the container in case of longer breaks and after the work has been
terminated. This can be done by briefly turning open and then closing the container
or by pulling the trigger guard and letting the paint into the original paint container.
2) Detach the container. Empty any remaining coating material back into the
material tin.
3) Clean the Container (Fig. 9, 6) and the Paint Container Seal (Fig. 9, 7).
4) Pour solvent or water into the container. Screw the container back on.
Do not use flammable materials for cleaning purposes.
5) Plug into the mains and press the ON/OFF switch and spray the solvent or water into
a container or a cloth.
6) Repeat the above procedure until the solvent or water emerging from the nozzle
is clear.
7) Turn the tool OFF and unplug.
CORRECT Even distance to the object.
INCORRECT An uneven distance will result in uneven paint
application.
EN
9