Kinderkraft MINK Manual De Uso página 26

• With one hand, hold the front edge of the seat. Put the fingers of the other hand under the
cover through the crotch strap opening (F). Pull the cover in the direction of the arrow until
you see a small gap between the harness adjuster (N) and the cover (Fig. 23).
• Lift the cover on the side of the headrest in the direction of the arrow shown in Figure 25.
• Pull the cover towards the lap belt guides (M) until you see a small gap, and then pull the
material from under the guide (Fig. 26). Pull out the crotch strap with the buckle (E, F) through
the opening in the cover.
Note: For safety reason, frequent removing is not recommended.
6.2 Installing the cover and sun protector
• Put the cover onto the shell. Put the crotch strap with the buckle (E, F) over the opening in
the cover.
• Thread the shoulder straps (D) through the holes (B) in the backrest (Fig. 27) and place the
strap pads.
•Pull the harness adjuster (N) through the opening in the cover. Then smooth the cover out
(Fig. 28).
• Tighten and secure the cover on the front edge of the seat (Fig. 29).
• Tighten and secure the cover on the seat headrest (Fig. 30).
• Attach the hooks to the corresponding slots on both sides of the seat (Fig. 31).
•Place the seat carrying handle in the car safety seat position (Fig. 2, position 3). Pull the
elastic strap and attach it in the corresponding slots on both sides of the seat (Fig. 32).
• Attach the sun protector to the seat and place it in the space between the seat and the
plastic element (Fig. 33). Holes in the protector and cover must match, so that they can be
secured with the mandrel in the plastic element. Pull the plastic part aside and put it on the
seat.
• Pull the elastic strap and attach it in the corresponding slots on both sides of the seat
(Fig. 34).
6.3 Cleaning
Use the original cover only, since it is essential for the safety of the seat.
The cover can be removed. Clean the cover in warm water (lower than 30°C) with mild
detergent, dry naturally. No drying.
• Plastic parts can be cleaned with soap and water. Do not use strong detergents (for example
solvents).
• Straps and tethers can be cleaned in soap water.
• Shoulder pads can be removed and cleaned in soap.
7. Warranty
1. All Kinderkraft products are covered by a 24-month warranty. The warranty period
begins on the date of releasing the product to the Buyer.
2. The warranty is valid for products sold in the following countries: France, Spain,
Germany, Poland, United Kingdom, Italy.
3. In countries not listed above warranty terms and conditions are determined by the Seller.
26