Important Safety Instructions; For Using Nailers - Hitachi NR65AK Manual De Instrucciones

English
READ AND UNDERSTAND ALL INSTRUCTIONS
1. OPERATORS AND OTHERS IN WORK AREA MUST WEAR SAFETY GLASSES WITH SIDE SHIELDS.
2. NEVER USE OXYGEN OR OTHER BOTTLED GASES. EXPLOSION MAY OCCUR.
3. NEVER DRIVE NAILS INTO METAL OR CONCRETE.
YES
• pre-punched holed
metal
• wood
4. ALWAYS BE AWARE OF POSITION OF FIRING HEAD.
YES
work surface
5. KEEP THE TOOL ALIGNED WITH THE PRE-PUNCHED METAL HOLE WHEN FIRING.
YES Zone
80 deg.
NO
50 deg.
Zone
WOOD
Metal hole
SAFETY

IMPORTANT SAFETY INSTRUCTIONS

MMMMFOR USING
When operating the Nailer, always wear safety glasses with side shields, and make sure others in
work area wear safety glasses, too.
Safety glasses must conform to the requirements of American National Standards Institute, ANSI
Z87.1 and provide protection against flying particles both from the front and side.
The employer must enforce the use of safety glasses by the Nailer operator and others in work
area.
Never use oxygen, combustible gases or any other bottled gases as a power source for the Nailer.
Use of the above gases is dangerous, as the Nailer will explode.
Use only clean, dry, regulated compressed air.
If the nail is driven into metal or concrete directly, it could ricochet and
NO
hurt yourself as well as others.
• no-holed metal
• concrete
When the firing head is pointed away from work surface, injuries can
NO
occur.
Insert the nail point in direct alignment to the pre-punched metal hole.
Do not align with the surface at an angle of less than 50 degrees.
NO
50 deg.
Zone
METAL
NAILERSMMlMM
DANGER
— 4 —