Safety Information - Grohe Blue Serie Manual De Instalación

USA

Safety information

This device may be used by children
over 8 years of age, as well as persons
with physical, sensory, or mental
disabilities or inadequate experience and
knowledge, if they are under supervision or
were instructed in the safe use of the
device and understand the resulting risks.
Children must not play with the device.
Cleaning and user maintenance must not
be carried out by children without
supervision.
Prevent danger resulting from damaged
power supply cables. In the case of
damage, the mains cable must be
replaced by the manufacturer or his
customer service department, or an equally
qualified person.
CO (carbon dioxide) is a gas and must not be
2
inhaled due to danger of suffocation.
The CO cylinder is pressurised. It must only be
2
operated in the vertical position.
The use of non-genuine GROHE CO
result in damage to the pressure-reducing valve.
In the case of damaged cooling circuit:
pull mains plug. Ventilate the room in which
the device is located well for a few minutes.
Inform customer service.
Splashing coolant can lead to eye injuries.
The coolant R134a is a natural gas with
high environmental compatibility, but
flammable. It does not damage the ozone
layer and does not increase the
greenhouse effect.
• Only connect the attached power cord with low-
power connection socket according to
IEC 60320-C13 to a suitable fused socket with at
least a 10 A and a ground fault circuit interrupter.
The socket must be freely accessible after
installation.
Do not seal ventilation openings on the
device enclosure or on surrounding
furniture.
• The system must not be transported with the
CO cylinder connected.
2
• The CO cylinder must not be maintained or
2
repaired by unauthorised persons.
• During cleaning, do not spray the cooler/
carbonator or the plug directly or indirectly with
water.
• The cooler/carbonator must be connected to a
permanent power supply.
• At the installation location, the cooler/carbonator,
CO
from mechanical damage, heat and direct
sunlight.
Do not install near heat sources, other ignition
sources or open fire.
• The cooler/carbonator must be placed in an
upright position.
• The cooler/carbonator must not be opened.
• Installation of the fitting and cooler/carbonator
with filter cartridge is only permitted in frost-free
rooms.
• The cooler/carbonator is only suitable for indoor
use.
• When transporting or installing the cooler/
carbonator, cooling fluid may have run into the
lines. In order to ensure that the cooling fluid has
run back, the cooler/carbonator may only be
installed following a pause of 24 hours.
• For optimal cooling performance, the system will
require a rest period of 6 hours after the
bottles can
2
installation.
• Do not use a damaged device.
• Following installation, the cooler/carbonator
must be cleaned before first use.
Note:
The cleaning kit (Prod. no.: 40 434 001) and the
accompanying adapter (Prod. no.: 40 694 000) can
be ordered at www.shop.grohe.com.
• After installing the cooler carbonator must not be
disconnected from the power.
• The fitting has a system-related run-on time of
approx. 1 second each time carbonated water is
drawn.
Notes on software and internet connection:
• In order to ensure the device operates with full
functionality, both the smartphone used and GROHE
Blue cooler must be connected to the internet, and
the device must have been installed successfully via
the GROHE ONDUS app beforehand. Otherwise, the
device will not be configured and no messages can
be sent.
• GROHE takes all necessary measures to ensure safe
and correct use. In the event of a malicious attack by
third parties, GROHE advises to install the latest
firmware and/or disconnect the device from the power
supply grid until you receive further information from
GROHE.
cylinder and filter system must be protected
2
18