Publicidad
Idiomas disponibles
Idiomas disponibles
iNSTALL
HiGH LiFT BAGGING
BLADES
(See Fig. 1)
i
_
CAUTION:
Blades
are sharp. Protect
j
your hands with gloves and/or wrap
blade with heavy cloth.
NOTE: Ifyou already have high lift bagging blades on your
mower, store the supplied blades in a safe place for future
use. Go on to step 2.
1.
Raise mower to highest position to allow access to
blades.
2.
Remove blade bolts by turning counterclockwise.
3.
Install bagging blades supplied with stamped "THIS
SIDE UP" facing up towards mower, or, blades stamped
with "GRASS SIDE" facing down towards grass.
IMPORTANT." T o ensure proper assembly, center hole in blade
must align with star pattern on mandrel assembly.
4.
Install and tighten blade bolts securely (45-55 Ft. Lbs.
torque).
STAR
PATTERN
BLADE BOLT
(SPECIAL)
_.,_
MANDREL
ASSEMBLY
HIGH LIFT
BAGGING
BLADE
HANG SUPPORT
ASSEMBLY
ON
REAR DRAWBAR
(See Fig. 2)
To determine which support assembly you have on
your tractor see illustrations below and compare them
to the drawbar located at the rear of your tractor.
o
o
O
o
o
O
O
DRAWBAR A
if your tractor is equipped
with this illustration call
1-800-633-3522
for a replacement
kit.
DRAWBAR
B
1.
Slide flanges of support assembly into drawbar slots
first, then, pivot backwards inserting pin into drawbar
pin hole.
2.
Be sure support assembly is seated properly, then
secure with retainer spring.
'%
SUPPORT
t
i
ASSEMBLY
/
7
DRAWBAR
SLOTS
(Drawbat
"A" shown)
INSERT
FLANGES
FIRST INTO
DRAWBAR
SLOTS
DRAWBAR
PIN HOLE
FIG. 2
RETAINER
SPRING
MOUNTING
COVER ASSEMBLY
TO
SUPPORT
ASSEMBLY
(See Fig. 3)
NOTE: For ease of assembly, you may wish to obtain the
assistance of another person for mounting cover assembly
to tractor.
1.
Lift cover and align cover brackets with support
assembly tubes.
2.
Slide cover assembly down onto the support tubes.
COVER
ASSEMBLY
SUPPORT
ASSEMBLY
03024
5
FIG. 3
Publicidad
