Connecting The Inlet Hose - Samsung DV42H5400 Serie Manual Del Usuario

Connecting the inlet hose (Steam model only)
The dryer must be connected to the cold water faucet using the new inlet hoses. Do not use old hoses.
1. Turn the cold water faucet off.
2, Attach the brass female end of the Y connector CA)to the cold water
faucet.
3. Attach the straight end of long hose (B) to the Y connector.
4, Using pliers, tighten the coupling with an additional two4hirds turn.
If the Y connector cannot be attached directly to the cold water
faucet, the short hose must be used.
(If space permits, please skip steps 5 to 8, and go directly to step 9.)
5,
6.
7.
8.
9.
Attach the short inlet hose (C} to the cold water faucet.
Screw on the coupling by hand until it is seated on the faucet. ___
Using the pliers, tighten the coupling with an additional two-thirds
turf].
Attach the Y connector CA) to the brass male end of the small hose. "
Screw on the coupling by hand until it is seated on the connector.
Using the pliers, tighten the coupling with an additional two4hirds
turf].
Attach the angled end of long hoses to the fill valve at the bottom of
the dryer rear frame. Screw on the coupling by hand until it is seated
on the fill valve connector.
10. Using pliers, tighten the coupling with an additional two-thirds turn.
11. Attach the washer hose (D) to the other side of the Y connector CA).
Screw on the hose coupling until it is tight. Using pliers, tighten the
coupling with an additional two thirds turn.
12. Check that the water faucets are on.
13. Check for leaks around the Y connector, faucets and hoses.
When you tighten the coupling with pliers, do not overtighten.This may damage the coupling.
English _18