Starting Instructions; Speed Start - Sears Craftsman 316.990100 Manual De Uso

i!lllIi!!!:!!ilii!!!i]i! i i ii!il!!!!i!Ii!; iiiii!t!iiii !!!! iii 11i!i!i!ii!l!iiilll t
NOTE: This unit can use a Speed Start
TM
Accessory!
Please refer to the Speed Start
TM
accessory operator's manual
for the proper use of this feature. (Items Sold Separately! Refer
to the Speed Start
TM
Accessory section of this manual for more
information about these Speed Start
TM
accessories.)
STARTING iNSTRUCTiONS
1. Mix gasoline with oil. Refer to Off and Fuel Mixing instructions.
2. Fill the fuel tank. Refer to Fueling the Unit.
NOTE: There is no need to turn the unit on. The On/Off switch is in
the ON (I) position at all times (Fig. 6).
3. Slowly press and release the primer bulb 10 times (Fig. 7). If fuel
cannot be seen in the primer bulb, press and release the primer
bulb until fuel is visible.
4. Move the choke lever to Position 1 (Fig. 7).
5. Crouch in the starting position (Fig. 8).
6. Insert the Speed Start
TM
accessory into the Speed Start
TM
port
(Fig. 22). Refer to the Operation section of the Speed Start
TM
accessory operator's manual.
7. Squeeze and hold the throttle control (Fig. 6). Run the Speed
Start
TM
accessory for 2 seconds.
NOTE: SQUEEZE and HOLD the throttle control for ALL further steps.
8. Continue to squeeze the throttle control. Move the choke lever
to Position 2 (Fig. 7).
9. Continue to squeeze the throttle control. Run the Speed Start
TM
accessory in intervals no longer than 2 seconds each until the
unit starts.
10. Remove the Speed Start
TM
accessory from the unit.
11. Continue to squeeze the throttle control. Allow the engine to
warm up for 30 to 60 seconds.
12. Continue to squeeze the throttle control. Move the choke lever
to Position 3 (Fig. 7) and continue warming the engine for an
additional 60 seconds. The unit may be used during this time.
NOTE: The engine is properly warmed up when it accelerates
without hesitation.
iF... the engine hesitates, return the choke lever to Position 2 (Fig. 7)
and continue the warm-up.
iF... the engine does not start, begin the starting procedure with
step 3.
iF... the engine fails to start after a few attempts, move the choke
lever to Position 3 and squeeze the throttle control. Run the
Speed Start
TM
accessory in intervals no longer than 2 seconds
each until the unit starts. The engine should start. If it does not,
repeat this instruction.
iF... the engine is already warm, begin the starting procedure with
step 8.
STOPPING iNSTRUCTiONS
1. Release the throttle control and allow the engine to idle.
2. Press and hold the On/Off switch in the OFF (O) position until
the engine comes to a complete stop (Fig. 6).
11