Hella OptiRAY FLASHING Instrucciones De Montaje página 13

EN
ENGLISH
FLASH SEQUENCE ADJUSTMENT
1. The lamp must be put in
operation (red to positive terminal
(plus +), blue to negative terminal
(minus -)).
2. The "Synchronization" input
(yellow) is connected to the positive
13
LAMP
SYNCHRONIZATION
1. Program each lamp individually
with the desired fl ash pattern as de-
scribed in the "Programming Mode"
instructions. (We recommend
selecting the same fl ash pattern for
all lamps to be synchronized.)
2. Connect the lamps as specifi ed in
the circuit diagram. Here, all yellow
lines are connected to one another.
terminal (plus +).
3. A er approx. 2 seconds the fl ash
sequence selection
mode is activated, the lamp now
starts fl ashing at approx. 1 Hz. A er
every fl ash cycle, the next fl ash
sequence is activated, although it
always starts with the fi rst fl ash
sequence. For example, if you want
+
–
red
yellow
to select the 4th fl ash sequence,
the "Select Flash Sequence" input
(yellow) needs to be disconnected
from positive terminal (plus +) a er
the 4th fl ash.
+
30
–
31
blue
...
...
+
–